Prusa3D Forum

Notifications

Clear all

Salomea

Groupe: Enregistré

A(ont) rejoint: 2019/01/24

Active Member

	Yes, I tried - there was no improvement. Dans le forum Hardware, firmware and software help	il y a 1 month
	I testes 3 different filaments: 2 of them were less than 1 m... Dans le forum Hardware, firmware and software help	il y a 1 month
	First layer perfect, later nothing sticks. Dans le forum Hardware, firmware and software help	il y a 1 month
	First layer perfect, later nothing sticks Dans le forum Hardware, firmware and software help	il y a 1 month
	Model preview on display screen (firmware 6) Dans le forum Hardware, firmware and software help	il y a 2 years
	Fortunately I didn't drink it 😉 I was careful using ethyl ... Dans le forum Hardware, firmware and software help	il y a 7 years
	Yes! It really worked! My filament is flowing well again 🙂 Dans le forum Hardware, firmware and software help	il y a 7 years
	I've immersed the nozzle in ethyl acetate (it's dedicated fo... Dans le forum Hardware, firmware and software help	il y a 7 years
	I've had similar problem today. I've cleared everything 3 ti... Dans le forum Hardware, firmware and software help	il y a 7 years

Statistiques du forum

595 Forums

70.6 K Sujets

494.5 K Messages

13 En-ligne

82 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé