Prusa3D Forum

Avisos

Vaciar todo

Salomea

Grupo: Registrado

Registrado: 2019/01/24

Active Member

	Yes, I tried - there was no improvement. En el foro Hardware, firmware and software help	hace 1 month
	I testes 3 different filaments: 2 of them were less than 1 m... En el foro Hardware, firmware and software help	hace 1 month
	First layer perfect, later nothing sticks. En el foro Hardware, firmware and software help	hace 1 month
	First layer perfect, later nothing sticks En el foro Hardware, firmware and software help	hace 1 month
	Model preview on display screen (firmware 6) En el foro Hardware, firmware and software help	hace 2 years
	Fortunately I didn't drink it 😉 I was careful using ethyl ... En el foro Hardware, firmware and software help	hace 7 years
	Yes! It really worked! My filament is flowing well again 🙂 En el foro Hardware, firmware and software help	hace 7 years
	I've immersed the nozzle in ethyl acetate (it's dedicated fo... En el foro Hardware, firmware and software help	hace 7 years
	I've had similar problem today. I've cleared everything 3 ti... En el foro Hardware, firmware and software help	hace 7 years

Estadísticas del Foro

595 Foros

70.6 K Temas

494.4 K Respuestas

13 En línea

82 K Miembros

Iconos del foro: El foro no contiene publicaciones sin leer El foro contiene publicaciones sin leer

Iconos de los Temas: No respondidos Respondido Activo Popular Fijo No aprobados Resuelto Privado Cerrado