Notifications
Clear all
Saij
Saij
Skupina: Registrovaný
Přidal se: 2025/04/30
Active Member
1
Yeah. The standard Prusa Profiles have them filled out.

In forum Assembly and first prints troubleshooting

před 7 years
Just did some testing with the first layer extrusion width. ...

In forum Assembly and first prints troubleshooting

před 7 years
That's the best result for the live-z I've got for this nozz...

In forum Assembly and first prints troubleshooting

před 7 years
I've attached the G-Code. But it's sliced for the MK2S - not...

In forum Assembly and first prints troubleshooting

před 7 years
Yes. Specially sliced it for this nozzle size.

In forum Assembly and first prints troubleshooting

před 7 years
First layer problem after changing to 0.25mm nozzle

In forum Assembly and first prints troubleshooting

před 7 years
But why does it stick for many hours after I clean it with a...

In forum Hardware, firmware and software help

před 7 years
I only print PLA and sometimes PETG.

In forum Hardware, firmware and software help

před 7 years
Weird adhesion problem

In forum Hardware, firmware and software help

před 7 years
I stumbled acros this post/problem because I have the same p...

In forum Hardware, firmware and software help

před 7 years
Layer Shifts at same height

In forum Hardware, firmware and software help

před 7 years
Maybe you put them on the wrong way around (not the position...

In forum Others (Archive)

před 9 years
Öhm... So currently I'm using Slic3r Prusa Edition 1.31.6 a...

In forum Print tips (Archive)

před 9 years
Rough Top Layer

In forum Print tips (Archive)

před 9 years
Stránka 6 / 6
Share: