Prusa3D Forum

Notifications

Clear all

sabarots0110

Grupa: Zarejestrowany

Dołączył: 2019/07/16

Active Member

	I finally figured it out!! i tightened the gear belt holder ... In forum Hardware, firmware and software help	5 years temu
	For the red circles, would that by a y issue or possibly and... In forum Hardware, firmware and software help	5 years temu
	Is that a solution just for the spacing or is that a solutio... In forum Hardware, firmware and software help	5 years temu
	The current is -.730 but it was at -.780 before, that new va... In forum Hardware, firmware and software help	5 years temu
	Terrible Prints Need Help In forum Hardware, firmware and software help	5 years temu

Statystyki Forum

559 Fora

62.9 K Tematy

442.9 K Posty

18 Online

67.7 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte