Prusa3D Forum

Notifications

Clear all

RonS

Groupe: Enregistré

A(ont) rejoint: 2023/05/10

Eminent Member

	Geesh, that was simple. Dans le forum PrusaSlicer	il y a 2 years
	Pretty Much normal Also, I did use that compare feature in... Dans le forum PrusaSlicer	il y a 2 years
	When I load your 3mf file in PS my settings are applied whic... Dans le forum PrusaSlicer	il y a 2 years
	I decided to open the 3mf file in Notepad ++ to see if I can... Dans le forum PrusaSlicer	il y a 2 years
	I think the problem is I'm comparing the two completely wron... Dans le forum PrusaSlicer	il y a 2 years
	I loaded both 3mf files in PS and selected compare. PS says ... Dans le forum PrusaSlicer	il y a 2 years
	Thank for responding Neophyl I tried the default ender 3 v... Dans le forum PrusaSlicer	il y a 2 years
	I raised the nozzle 0.05mm and the bottom looks great. Thank... Dans le forum PrusaSlicer	il y a 2 years
	Thanks for that, I had no idea. Here is a 3mf file generated... Dans le forum PrusaSlicer	il y a 2 years
	Yes, this file works on my computer, it was generated by Fus... Dans le forum PrusaSlicer	il y a 2 years
	I just doubled checked my first layer extrusion width and it... Dans le forum PrusaSlicer	il y a 2 years
	The settings for the file included in the zip file are the s... Dans le forum PrusaSlicer	il y a 2 years
	Yes I did twice... I'll try again... I do see it next to [Ch... Dans le forum PrusaSlicer	il y a 2 years
	Reattaching File (Do I need to wait for a moderator to appro... Dans le forum PrusaSlicer	il y a 2 years
	Need help dialing in Prusa for Ender V2 Neo Dans le forum PrusaSlicer	il y a 2 years
	The Creality presets are still in Alpha and really didn't wo... Dans le forum PrusaSlicer	il y a 2 years
	Thank you for taking the time to help me Diem In my first po... Dans le forum PrusaSlicer	il y a 2 years
	I check the diameter of the filament and its pretty consiste... Dans le forum PrusaSlicer	il y a 2 years
	I tried that at 50% and 100% and there was no change Dans le forum PrusaSlicer	il y a 2 years
	Gap between top layer and side wall Dans le forum PrusaSlicer	il y a 2 years

Statistiques du forum

566 Forums

63.2 K Sujets

444.3 K Messages

20 En-ligne

68.1 K Membres

Le dernier des messages: First layer of some objects *sometimes* gets 'engraved' into the smooth PEI Sheet (PLA) Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé