ron – Aktivita – Prusa3D Forum

Notifications

Clear all

ron

Skupina: Registrovaný

Přidal se: 2016/10/20

Estimable Member

	Thanks. My thinking of the layer time in Slic3r was totally ... In forum Print tips (Archive)	před 9 years
	I was dealing with similar problem because of fan failure (c... In forum Prusa i3 kit (Archive)	před 9 years
	I noticed an issue with support parameters. If you upgrade t... In forum Software (Archive)	před 9 years
	Increase adhesion by using an adhesive product: glue stick o... In forum Prusa i3 kit (Archive)	před 9 years
	Updated to 1.33.8. Layer editing freeze Slic3r every time, t... In forum Software (Archive)	před 9 years
	So for those that are familiar with this, the printer will s... In forum Print tips (Archive)	před 9 years
	First I'm happy that a guru answer my request (I'm a 2 month... In forum Print tips (Archive)	před 9 years
	Indeed nice device. I didn't even thought about converter fr... In forum Improvements (Archive)	před 9 years
	5V power supply for Raspberry PI. In forum Improvements (Archive)	před 9 years
	Base of ABS small pulleys hard to get good In forum Print tips (Archive)	před 9 years
	"minimum time per layer" I don't find where the setting is (... In forum Software (Archive)	před 9 years
	Once uploaded, the file size should be different. And contro... In forum Print tips (Archive)	před 9 years
	Did-you check the uploaded gcode file? What gives Gcode View... In forum Print tips (Archive)	před 9 years
	I purchased a fully assembled PMK2 and it xas delivered on d... In forum Prusa i3 kit (Archive)	před 9 years

Stránka 12 / 12 Předchozí

Fórum Statistiky

595 Fóra

70.2 K Témata

491.2 K Příspěvky

15 Online

81.3 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed