Aktywność
 
Notifications
Clear all
robotics
robotics
Grupa: Zarejestrowany
Dołączył: 2020/07/03
Active Member
1
Thanx. That link explains a lot.

In forum Assembly and first prints troubleshooting

4 years temu
The following settings worked for my box: first level z = -1...

In forum Assembly and first prints troubleshooting

4 years temu
I did the 3x3 test with 9 different settings. Starting from ...

In forum Assembly and first prints troubleshooting

4 years temu
Thanx for the reply. I did a conversion fault. The numbers I...

In forum General discussion, announcements and releases

4 years temu
minimum thickness of walls, floor with PLA

In forum General discussion, announcements and releases

4 years temu
Bed cleaned and cleaned. I found where I can change the bed ...

In forum Assembly and first prints troubleshooting

4 years temu
I should have said a curled corner, a corner that was no lon...

In forum Assembly and first prints troubleshooting

4 years temu
Thanx for all the suggestions.I did change the bed leveling ...

In forum Assembly and first prints troubleshooting

4 years temu
RE: nozzle grabbing first layer

In forum Assembly and first prints troubleshooting

4 years temu
nozzle grabbing first layer

In forum Assembly and first prints troubleshooting

4 years temu
FS v0.4 or newer

In forum Assembly and first prints troubleshooting

4 years temu
Thanx for the great advice. Wonderful info for Prusa to put...

In forum General discussion, announcements and releases

4 years temu
frequency when to unload filament

In forum General discussion, announcements and releases

4 years temu
fixed the problem by increasing the tension in the pulley.

In forum Assembly and first prints troubleshooting

4 years temu
Additional measuring indicates the bed moves 218mm from one...

In forum Assembly and first prints troubleshooting

4 years temu
Y axis calibration fails

In forum Assembly and first prints troubleshooting

4 years temu
Share: