Benachrichtigungen
Alles löschen
robotics
robotics
Gruppe: Registriert
Beigetreten: 2020/07/03
Active Member
1
Thanx. That link explains a lot.

Im Forum Assembly and first prints troubleshooting

Vor 4 years
The following settings worked for my box: first level z = -1...

Im Forum Assembly and first prints troubleshooting

Vor 4 years
I did the 3x3 test with 9 different settings. Starting from ...

Im Forum Assembly and first prints troubleshooting

Vor 4 years
Thanx for the reply. I did a conversion fault. The numbers I...

Im Forum General discussion, announcements and releases

Vor 4 years
minimum thickness of walls, floor with PLA

Im Forum General discussion, announcements and releases

Vor 4 years
Bed cleaned and cleaned. I found where I can change the bed ...

Im Forum Assembly and first prints troubleshooting

Vor 4 years
I should have said a curled corner, a corner that was no lon...

Im Forum Assembly and first prints troubleshooting

Vor 4 years
Thanx for all the suggestions.I did change the bed leveling ...

Im Forum Assembly and first prints troubleshooting

Vor 4 years
RE: nozzle grabbing first layer

Im Forum Assembly and first prints troubleshooting

Vor 4 years
nozzle grabbing first layer

Im Forum Assembly and first prints troubleshooting

Vor 4 years
FS v0.4 or newer

Im Forum Assembly and first prints troubleshooting

Vor 4 years
Thanx for the great advice. Wonderful info for Prusa to put...

Im Forum General discussion, announcements and releases

Vor 4 years
frequency when to unload filament

Im Forum General discussion, announcements and releases

Vor 4 years
fixed the problem by increasing the tension in the pulley.

Im Forum Assembly and first prints troubleshooting

Vor 4 years
Additional measuring indicates the bed moves 218mm from one...

Im Forum Assembly and first prints troubleshooting

Vor 4 years
Y axis calibration fails

Im Forum Assembly and first prints troubleshooting

Vor 4 years
Teilen: