Benachrichtigungen
Alles löschen
robotics
Gruppe: Registriert
Beigetreten: 2020/07/03
Active Member
1
| Thanx. That link explains a lot. | Vor 5 years | |
| The following settings worked for my box: first level z = -1... | Vor 5 years | |
| I did the 3x3 test with 9 different settings. Starting from ... | Vor 5 years | |
| Thanx for the reply. I did a conversion fault. The numbers I... | Vor 5 years | |
| minimum thickness of walls, floor with PLA | Vor 5 years | |
| Bed cleaned and cleaned. I found where I can change the bed ... | Vor 5 years | |
| I should have said a curled corner, a corner that was no lon... | Vor 5 years | |
| Thanx for all the suggestions.I did change the bed leveling ... | Vor 5 years | |
| RE: nozzle grabbing first layer | Vor 5 years | |
| nozzle grabbing first layer | Vor 5 years | |
| FS v0.4 or newer | Vor 5 years | |
| Thanx for the great advice. Wonderful info for Prusa to put... | Vor 5 years | |
| frequency when to unload filament | Vor 5 years | |
| fixed the problem by increasing the tension in the pulley. | Vor 5 years | |
| Additional measuring indicates the bed moves 218mm from one... | Vor 5 years | |
| Y axis calibration fails | Vor 5 years |