|
Is there a 5V, USB-A or USB-C output available on XL to powe... En el foro General discussion, announcements and releases |
hace 4 weeks |
|
How to change infill extruder for painted parts En el foro PrusaSlicer |
hace 4 months |
|
Cheap Chinese flash lights do the same. 🙁 En el foro Hardware, firmware and software help |
hace 4 months |
|
yes, all 5 tools are flickering, seems to me there is almost... En el foro Hardware, firmware and software help |
hace 4 months |
|
Toolhead LED flickering En el foro Hardware, firmware and software help |
hace 4 months |
|
Are you still using original petg idler levers, resp. have y... En el foro Hardware, firmware and software help |
hace 4 months |
|
(1) The reason for a lower temp is my levers are still origi... En el foro How do I print this? (Printing help) |
hace 4 months |
|
How to print Nylon (Co-PA) ? En el foro How do I print this? (Printing help) |
hace 4 months |
|
I have downgraded to 6.0.1 couple of months ago and still us... En el foro Hardware, firmware and software help |
hace 5 months |
|
I have contacted support again and just recommended me to re... En el foro Hardware, firmware and software help |
hace 5 months |
|
I have these stuck issues so often, that almost all prints a... En el foro Hardware, firmware and software help |
hace 5 months |
|
I have also not resolved the issue fully. Some heads are sim... En el foro Hardware, firmware and software help |
hace 5 months |
|
Thank you, I have the same (board fan) already applied. My e... En el foro Hardware, firmware and software help |
hace 7 months |
|
I've had a chat with support and was told there were some te... En el foro Hardware, firmware and software help |
hace 7 months |
|
I have very similar issue with filament stuck on my XL for c... En el foro Hardware, firmware and software help |
hace 7 months |
|
Hope someone with the already built enclosure can describe t... En el foro Hardware, firmware and software help |
hace 7 months |
|
Thank you for the explanation. Is there a link for a wiring ... En el foro Hardware, firmware and software help |
hace 7 months |
|
Does it mean the fan signal/power is provided by the electro... En el foro Hardware, firmware and software help |
hace 7 months |
|
XL Enclosure fan En el foro Hardware, firmware and software help |
hace 7 months |
|
Dobry den, potreboval by som vyhladit vytlacok a na internet... En el foro Nejlepší výtisky & tiskové tipy |
hace 7 months |
