|
How to change infill extruder for painted parts In forum PrusaSlicer |
před 2 months |
|
Cheap Chinese flash lights do the same. 🙁 In forum Hardware, firmware and software help |
před 2 months |
|
yes, all 5 tools are flickering, seems to me there is almost... In forum Hardware, firmware and software help |
před 2 months |
|
Toolhead LED flickering In forum Hardware, firmware and software help |
před 2 months |
|
Are you still using original petg idler levers, resp. have y... In forum Hardware, firmware and software help |
před 2 months |
|
(1) The reason for a lower temp is my levers are still origi... In forum How do I print this? (Printing help) |
před 2 months |
|
How to print Nylon (Co-PA) ? In forum How do I print this? (Printing help) |
před 2 months |
|
I have downgraded to 6.0.1 couple of months ago and still us... In forum Hardware, firmware and software help |
před 3 months |
|
I have contacted support again and just recommended me to re... In forum Hardware, firmware and software help |
před 3 months |
|
I have these stuck issues so often, that almost all prints a... In forum Hardware, firmware and software help |
před 3 months |
|
I have also not resolved the issue fully. Some heads are sim... In forum Hardware, firmware and software help |
před 3 months |
|
Thank you, I have the same (board fan) already applied. My e... In forum Hardware, firmware and software help |
před 5 months |
|
I've had a chat with support and was told there were some te... In forum Hardware, firmware and software help |
před 5 months |
|
I have very similar issue with filament stuck on my XL for c... In forum Hardware, firmware and software help |
před 5 months |
|
Hope someone with the already built enclosure can describe t... In forum Hardware, firmware and software help |
před 5 months |
|
Thank you for the explanation. Is there a link for a wiring ... In forum Hardware, firmware and software help |
před 5 months |
|
Does it mean the fan signal/power is provided by the electro... In forum Hardware, firmware and software help |
před 5 months |
|
XL Enclosure fan In forum Hardware, firmware and software help |
před 5 months |
|
Dobry den, potreboval by som vyhladit vytlacok a na internet... In forum Nejlepší výtisky & tiskové tipy |
před 5 months |
|
I have used newly sliced files only. However the problem is ... In forum General discussion, announcements and releases |
před 6 months |
