|
I would try and install the heater block so that it's as far... In forum Hardware, firmware and software help |
před 5 years |
|
I've owned or used 3 i3mega printers from Anycubic and have ... In forum Hardware, firmware and software help |
před 5 years |
|
I think the assembled hotends already have thermal paste in ... In forum Hardware, firmware and software help |
před 5 years |
|
Cool I started repairing my extruder the other day and since... In forum Hardware, firmware and software help |
před 5 years |
|
The fins are supposedly reinforced on the r5 parts, so is th... In forum Hardware, firmware and software help |
před 5 years |
|
I don’t know, that’s why I was asking. The r5 version on git... In forum Hardware, firmware and software help |
před 5 years |
|
The photos are of new parts, never used or installed. In forum Hardware, firmware and software help |
před 5 years |
|
Correct photo 2
Attachment removed In forum Hardware, firmware and software help |
před 5 years |
|
Correct photo 1
Attachment removed In forum Hardware, firmware and software help |
před 5 years |
|
Check out my later post. Oops! In forum Hardware, firmware and software help |
před 5 years |
|
Opposite side photo
Attachment removed In forum Hardware, firmware and software help |
před 5 years |
|
The part on the left is the one I recently received from Pru... In forum Hardware, firmware and software help |
před 5 years |
|
It’s a lot to go through just to replace one part, more so t... In forum Hardware, firmware and software help |
před 5 years |
|
They just told me to glue it and print my own replacement bu... In forum Hardware, firmware and software help |
před 5 years |
|
Sure, I didn’t expect the glue to hold permanently. Prusa su... In forum Hardware, firmware and software help |
před 5 years |
|
Between 210 and 225 for Pla prior to the break. I then print... In forum Hardware, firmware and software help |
před 5 years |
|
This is what’s happened.
Attachment removed In forum Hardware, firmware and software help |
před 5 years |
|
I chatted with Prusa support yesterday regarding the files f... In forum Hardware, firmware and software help |
před 5 years |
|
I have had this experience with many PLA filaments, but not ... In forum Hardware, firmware and software help |
před 5 years |
|
I just bought (and printed too w/petg) a replacement part fo... In forum Hardware, firmware and software help |
před 5 years |
