Notifications
Clear all
Rob Latour
Rob Latour
Group: Registered
Joined: 2019/08/27
Eminent Member
2
take a look here:

In forum How do I print this? (Printing help)

6 months ago
As an update ... after replacing the nozzle and the PTFE tub...

In forum General discussion, announcements and releases

6 months ago
Thank you, I appreciate your follow up on this. I had an on...

In forum General discussion, announcements and releases

6 months ago
Currently they are set at: Slice gap closing radius: 0.04...

In forum General discussion, announcements and releases

6 months ago
Print is now coming out different than it did in the past - ...

In forum General discussion, announcements and releases

6 months ago
Here by the way is the 3D model for the print: I have a MK3...

In forum General discussion, announcements and releases

7 months ago
@fucher You should aim for better than that. I agree, I have...

In forum General discussion, announcements and releases

7 months ago
as an update, I am still getting crashes but far far fewer t...

In forum Hardware, firmware and software help

7 months ago
as an update, I am still getting crashes but far far fewer t...

In forum General discussion, announcements and releases

7 months ago
It could be those things, but I found this post re frequent ...

In forum General discussion, announcements and releases

7 months ago
I'm having this problem too - using PTEG for a cylindrical m...

In forum Hardware, firmware and software help

7 months ago
Now I am getting several "Y Crash Detected" errors - where ...

In forum General discussion, announcements and releases

7 months ago
my settings said crash detection was OFF; I turned it on, ti...

In forum General discussion, announcements and releases

7 months ago
Print shifting to the right or left mid way through printing

In forum General discussion, announcements and releases

7 months ago
I hadn't noticed but on the printer's lcd screen it was sayi...

In forum Hardware, firmware and software help

2 years ago
Thanks I just ordered some PTEG.

In forum General discussion, announcements and releases

2 years ago
clearly PLA was not the right choice - what filament do you ...

In forum General discussion, announcements and releases

2 years ago
Thanks very much, but I've decided to let it ride for a whil...

In forum Hardware, firmware and software help

2 years ago
Well, I tried it without printing the Arc Welder version, an...

In forum Hardware, firmware and software help

2 years ago
Thank you. I do have the Octolapse plug in installed, but am...

In forum Hardware, firmware and software help

2 years ago
Page 1 / 2
Share: