Notifications
Clear all
rnbarrett
Skupina: Registrovaný
Přidal se: 2022/03/22
Active Member
1
|
I use this in my filament change g-code. This will move the... In forum PrusaSlicer |
před 1 year | |
|
it's supposed to be part of the first line because it's a ma... In forum PrusaSlicer |
před 2 years | |
|
This code: M600 ; change to filament for extruder
{... In forum PrusaSlicer |
před 2 years | |
|
I basically combined most of everything above to print @Lock... In forum PrusaSlicer |
před 2 years | |
| That's a good point. Thank you. | před 3 years | |
| Thank you for the detailed reply. I'm stepping up from an E... | před 3 years | |
| MK3S+ kit ordered, any reason I should not install Revo Six ... | před 3 years |