Prusa3D Forum

Notifications

Clear all

rmenousek

Skupina: Registrovaný

Přidal se: 2022/07/04

Active Member

	Also having this issue. I disassembled the hotend, replaced ... In forum Hardware, firmware and software help	před 12 months
	Yes, once heated up said remove filament. Came right out. ... In forum General discussion, announcements and releases	před 2 years
	See my last post. Yes it was filament. In forum General discussion, announcements and releases	před 2 years
	Duh. It was the filament. When I went through the setup it... In forum General discussion, announcements and releases	před 2 years
	Help!! There is some kind of wire sticking out about 5 inche... In forum General discussion, announcements and releases	před 2 years

Fórum Statistiky

559 Fóra

62.9 K Témata

442.9 K Příspěvky

23 Online

67.7 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed