Prusa3D Forum

Notifications

Clear all

rmenousek

Group: Registered

Joined: 2022/07/04

Active Member

	Also having this issue. I disassembled the hotend, replaced ... In forum Hardware, firmware and software help	12 months ago
	Yes, once heated up said remove filament. Came right out. ... In forum General discussion, announcements and releases	2 years ago
	See my last post. Yes it was filament. In forum General discussion, announcements and releases	2 years ago
	Duh. It was the filament. When I went through the setup it... In forum General discussion, announcements and releases	2 years ago
	Help!! There is some kind of wire sticking out about 5 inche... In forum General discussion, announcements and releases	2 years ago

Forum Statistics

559 Forums

62.9 K Topics

442.9 K Posts

20 Online

67.7 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed