Activity
 
Notifications
Clear all
rinkel
rinkel
Group: Registered
Joined: 2022/01/30
Reputable Member
5
I also did the swap a few months ago (photos in vfa topic) b...

In forum User mods

1 month ago
Yes, i have performed the calibration about 50 times. I also...

In forum Hardware, firmware and software help

2 months ago
Just to let you know, i sold my Core One.I might buy one aga...

In forum Hardware, firmware and software help

2 months ago
I cannot send it back for refund anymore, but decided to sel...

In forum Hardware, firmware and software help

3 months ago
As i mentioned before, the toothed idlers did not help at al...

In forum Hardware, firmware and software help

3 months ago
They've sent me a new planetary gear set. Did not help unfor...

In forum Hardware, firmware and software help

3 months ago
I have done this modification, toothed idlers. I can tell yo...

In forum Hardware, firmware and software help

3 months ago
No effect at all. Still has VFA

In forum Hardware, firmware and software help

3 months ago
Today i installed toothed idlers, result: none.

In forum Hardware, firmware and software help

3 months ago
There is a working profile for OrcaSlicer, i'm currently usi...

In forum Hardware, firmware and software help

4 months ago
Gave it some tries, but got the error every time. I think th...

In forum Hardware, firmware and software help

4 months ago
YGK3D has found the same issue. You can watch it here at 14:...

In forum Hardware, firmware and software help

4 months ago
I saw this one too.I also have bad layer stacking as he desc...

In forum Hardware, firmware and software help

4 months ago
You could use a buck converter to go down from 24v to 12v. B...

In forum Hardware, firmware and software help

4 months ago
I also have a P1S, which has a lot of VFA, and yes, increasi...

In forum Hardware, firmware and software help

4 months ago
I have printed a lot of PC on my Voron and now some on the C...

In forum General discussion, announcements and releases

4 months ago
Solving this VFA issue is not easy. The X1C and P1S also hav...

In forum General discussion, announcements and releases

4 months ago
I have built a Voron Trident. After tinkering and upgrading ...

In forum General discussion, announcements and releases

4 months ago
F5'ing on the github for about a week now... I've tried ev...

In forum Hardware, firmware and software help

4 months ago
Leadscrew alignment helper:

In forum Hardware, firmware and software help

5 months ago
Page 1 / 13
Share: