|
Kaizers,
If you are going to be using the new heat block yo... In forum Prusa i3 kit (Archive) |
9 years temu |
|
The firmware that you have mentioned is for the Lulzbot TAZ2... In forum Prusa i3 kit (Archive) |
9 years temu |
|
Cristian,
I had the same problem and just replaced the M3x1... In forum Others (Archive) |
9 years temu |
|
That would require a dual extruder, chimera or cyclops setup... In forum Others (Archive) |
9 years temu |
|
Thanks. I was more concerned with the hole sizes than assemb... In forum Prusa i3 kit (Archive) |
9 years temu |
|
MK2 Upgrade part In forum Prusa i3 kit (Archive) |
9 years temu |
|
Zach,
Under Advanced uncheck "Merge all outlines into a sin... In forum General discussion, announcements and releases |
9 years temu |
|
Darknico,
I have noticed this as well since I started using... In forum General discussion, announcements and releases |
9 years temu |
|
Each slicer has it's own caveats. I personally use Simplify3... In forum Software (Archive) |
9 years temu |
|
You can find those options in the Printer Settings tab and t... In forum Others (Archive) |
9 years temu |
|
Peter,
With the correct resistors soldered in place it is f... In forum Improvements (Archive) |
9 years temu |
|
Where I work these are called "Unintended Features".
Anyway... In forum Others (Archive) |
9 years temu |
|
Interesting, I don't get the bumps but I do get the grid lin... In forum Others (Archive) |
9 years temu |
|
Is it possible that you have changed the Feed Rate on the LC... In forum Prusa i3 kit (Archive) |
9 years temu |
|
Jim,
If you want to power your pi from the printer power su... In forum Software (Archive) |
9 years temu |
|
I agree with Peter. OctoPrint is easy enough to set up and t... In forum Software (Archive) |
9 years temu |
|
Y-Axis skipping In forum Others (Archive) |
9 years temu |
|
Peter
I'm definitely not discounting your experience with t... In forum Others (Archive) |
9 years temu |
|
I have 1.5mm retraction distance in S3D and 0.8mm in Slic3r,... In forum Others (Archive) |
9 years temu |
|
It's definitely not recommended to use Z-Lift/Z-Hop for a Co... In forum Software (Archive) |
9 years temu |
