|
I would check the retraction settings. If it retracts too mu... In forum Others (Archive) |
9 years temu |
|
I ran into a similar situation when building mine and I had ... In forum Prusa i3 kit (Archive) |
9 years temu |
|
My OCD would take over and I would have to fix it. In forum Others (Archive) |
9 years temu |
|
I actually have 2 spots on my PEI sheet that peeled up after... In forum Others (Archive) |
9 years temu |
|
Peter,
Don't worry about the rant. 😀
I don't think that ... In forum Others (Archive) |
9 years temu |
|
Peter,
I'm pretty sure with auto bed leveling you cannot ru... In forum Others (Archive) |
9 years temu |
|
Also, make sure you have disconnected any slicers/print prog... In forum Others (Archive) |
9 years temu |
|
I ran into the exact same issue.
First, you need to adjust ... In forum Others (Archive) |
9 years temu |
|
I agree with David. If it is correct and you're still having... In forum Others (Archive) |
9 years temu |
|
Francesco,
Just by looking at the video you posted it seems... In forum Others (Archive) |
9 years temu |
|
Josef,
Where is the anti-aliasing? I have looked all over t... In forum Others (Archive) |
9 years temu |
|
On small infill distances that is normal. Nothing to worry a... In forum Others (Archive) |
9 years temu |
|
Todd,
Sorry for the delay. Here is the one I have been usin... In forum Others (Archive) |
9 years temu |
|
With the glue, water is your friend. I would wet a paper tow... In forum Others (Archive) |
9 years temu |
|
Todd,
Be careful with the exotic filaments like Glow-in-the... In forum Others (Archive) |
9 years temu |
|
Todd,
I believe it is this...
It looks like the 1.75mm is ... In forum Others (Archive) |
9 years temu |
|
Adam & Darryl,
Glad everything is back in working order... In forum Others (Archive) |
9 years temu |
|
Hi Peter,
Since I don't have an MK2 yet I can't tell for ce... In forum Others (Archive) |
9 years temu |
|
Hi Damian,
This definitely looks like underextrusion. You c... In forum Others (Archive) |
9 years temu |
|
Kevin
For the first layer I have been using 0.44 and then 0... In forum Print tips (Archive) |
9 years temu |
