Notifications
Clear all
Richard D
Richard D
Skupina: Registrovaný
Přidal se: 2021/01/09
Trusted Member
3
The relatively cheap cost of the whole hotend assembly - and...

In forum General discussion, announcements and releases

před 2 years
The Bambu Labs printer is not without its faults; for my par...

In forum General discussion, announcements and releases

před 2 years
FWLIW, I've used the high temp plate with PLA and no glue st...

In forum General discussion, announcements and releases

před 2 years
FWVLIW, I run a small side-hustle based on the advantages th...

In forum General discussion, announcements and releases

před 2 years
Will do. Although by starting again and following it all th...

In forum How do I print this? (Printing help)

před 2 years
Thanks. Yes, I'd read those posts (plus a couple of others)...

In forum How do I print this? (Printing help)

před 2 years
Multicolor print with manual MMU - printer pauses after prim...

In forum How do I print this? (Printing help)

před 2 years
FWIW, I'm pretty sure that my grief was the filament sensor;...

In forum Hardware, firmware and software help

před 2 years
Mine has eaten one. I must get around to installing the wif...

In forum General discussion, announcements and releases

před 2 years
I've been suffering from random filament unloads over the la...

In forum Hardware, firmware and software help

před 2 years
Interesting; I sell a few board game bits on Etsy, so the co...

In forum General discussion, announcements and releases

před 2 years
Not really a gimmick. Firstly they allow multiple rolls of t...

In forum General discussion, announcements and releases

před 2 years
But that is the way of the world - appliances that 'just wor...

In forum General discussion, announcements and releases

před 2 years
The vast majority of consumers want something that just work...

In forum General discussion, announcements and releases

před 2 years
Thanks. The filament is actually beige rather than white (a...

In forum How do I print this? (Printing help)

před 2 years
I’m watching this with interest. I’ve been waiting for the ...

In forum General discussion, announcements and releases

před 2 years
Periodic underextrusion, leading to repeated lines?

In forum How do I print this? (Printing help)

před 2 years
As John says. I’m not sure quite what it was, but it went a...

In forum Hardware, firmware and software help

před 2 years
I have had this issue a few times - with PLA as well as with...

In forum How do I print this? (Printing help)

před 2 years
Need to be careful with some Temp Towers; if it's just the m...

In forum How do I print this? (Printing help)

před 2 years
Stránka 1 / 5
Share: