|
For glue stick, you can apply it to the bed for any filament... Im Forum Others (Archive) |
Vor 8 years |
|
Glue stick, it lasts for several prints. Im Forum Others (Archive) |
Vor 8 years |
|
None of that helped... i mounted the card and tried to copy ... Im Forum User mods - OctoPrint, enclosures, nozzles, ... |
Vor 8 years |
|
Chat or email support, you have a bad wire on your print fan... Im Forum Others (Archive) |
Vor 8 years |
|
I've done some work to get PETG and S3D working with my Mk3.... Im Forum Others (Archive) |
Vor 8 years |
|
Many Thanks!
Andy
I've checked, and my printer currently... Im Forum User mods - OctoPrint, enclosures, nozzles, ... |
Vor 8 years |
|
I have attached it for feedback and suggestions. Please test... Im Forum General discussion, announcements and releases |
Vor 8 years |
|
I have been slowly honing an S3D profile for my Makergeeks P... Im Forum General discussion, announcements and releases |
Vor 8 years |
|
I had the same issue, print fan wire broke where the pinda w... Im Forum Hardware, firmware and software help |
Vor 8 years |
|
On windows you would map a network drive to: \\IP_Address\UP... Im Forum User mods - OctoPrint, enclosures, nozzles, ... |
Vor 8 years |
|
Here is the config that works for me, replace the items in r... Im Forum User mods - OctoPrint, enclosures, nozzles, ... |
Vor 8 years |
|
I´ll release a V2 of my FFF profile later on.
I will look ... Im Forum General discussion, announcements and releases |
Vor 8 years |
|
If ocotprint does not auto expand, you can do it via the ras... Im Forum User mods - OctoPrint, enclosures, nozzles, ... |
Vor 8 years |
|
I placed the Pinda probe wire first then the fan wire. I als... Im Forum Others (Archive) |
Vor 8 years |
|
I did receive the same exact error but it was the fan wire. ... Im Forum Others (Archive) |
Vor 8 years |
|
I had a similar issue that turned out to be a bad print fan ... Im Forum Others (Archive) |
Vor 8 years |
|
That sounds like what I will spend New Year's day doing 😀 Im Forum Others (Archive) |
Vor 8 years |
|
Print Fan Failure Im Forum Others (Archive) |
Vor 8 years |
