Prusa3D Forum

Notifications

Clear all

Red Towel

Groupe: Enregistré

A(ont) rejoint: 2021/09/04

Active Member

	so im getting more or less the same result except now its no... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Thanks . ill give that a try when i get acetone. Dans le forum How do I print this? (Printing help)	il y a 3 years
	i just gave the bed a wash in dish soap and water. could it... Dans le forum How do I print this? (Printing help)	il y a 3 years
	cylinder experiment Dans le forum How do I print this? (Printing help)	il y a 3 years
	thats a great idea ! however , id like to see if i can ache... Dans le forum How do I print this? (Printing help)	il y a 3 years
	the density is to increase weight . ill try adjusting my lay... Dans le forum How do I print this? (Printing help)	il y a 3 years
	ok so i adjusted to what i think is more consistent with goo... Dans le forum How do I print this? (Printing help)	il y a 3 years
	thanks . ill check it out right now . Dans le forum How do I print this? (Printing help)	il y a 3 years
	first layer z cal Dans le forum How do I print this? (Printing help)	il y a 3 years
	trying to print a cylinder 95% infill with 3d honeycomb, pri... Dans le forum How do I print this? (Printing help)	il y a 3 years

Statistiques du forum

559 Forums

63 K Sujets

443.1 K Messages

19 En-ligne

67.8 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé