Prusa3D Forum

Notifications

Clear all

Red Towel

Skupina: Registrovaný

Přidal se: 2021/09/04

Active Member

	so im getting more or less the same result except now its no... In forum How do I print this? (Printing help)	před 3 years
	Thanks . ill give that a try when i get acetone. In forum How do I print this? (Printing help)	před 3 years
	i just gave the bed a wash in dish soap and water. could it... In forum How do I print this? (Printing help)	před 3 years
	cylinder experiment In forum How do I print this? (Printing help)	před 3 years
	thats a great idea ! however , id like to see if i can ache... In forum How do I print this? (Printing help)	před 3 years
	the density is to increase weight . ill try adjusting my lay... In forum How do I print this? (Printing help)	před 3 years
	ok so i adjusted to what i think is more consistent with goo... In forum How do I print this? (Printing help)	před 3 years
	thanks . ill check it out right now . In forum How do I print this? (Printing help)	před 3 years
	first layer z cal In forum How do I print this? (Printing help)	před 3 years
	trying to print a cylinder 95% infill with 3d honeycomb, pri... In forum How do I print this? (Printing help)	před 3 years

Fórum Statistiky

559 Fóra

63 K Témata

443.1 K Příspěvky

18 Online

67.8 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed