|
It Sems, that Internet Streaming also works with FW3.1.3 Im Forum Buddy3D |
Vor 5 days |
|
Yes, can confirm the manual update to 3.1.3 was working fine... Im Forum Buddy3D |
Vor 6 days |
|
Hi, normally If a New Version is Released, This is written d... Im Forum Buddy3D |
Vor 2 months |
|
My fingers were faster than my brain, I apologize. The solu... Im Forum OpenPrintTag |
Vor 2 months |
|
The Solution under had worked for me Im Forum OpenPrintTag |
Vor 2 months |
|
I was only scanning the QR-code from a prusament spool, then... Im Forum OpenPrintTag |
Vor 3 months |
|
I had the Issue on the Core One cam with the new Firmware 3.... Im Forum Buddy3D |
Vor 3 months |
|
Ok, found it! my fault. I thought the sd-card was formatted ... Im Forum Buddy3D |
Vor 3 months |
|
Sorry for the late reply,I've tried the downgrade to 3.1.0 w... Im Forum Buddy3D |
Vor 3 months |
|
@ssmith
yes i‘m using the iOS
Version: 1.13.3+287
tes... Im Forum OpenPrintTag |
Vor 3 months |
|
Yes, cloning data from the QR of a Spool Prusament onto a bl... Im Forum OpenPrintTag |
Vor 3 months |
|
@Pomidoor: not a joke at all, with FW 3.1.1 the Cam was fine... Im Forum Buddy3D |
Vor 3 months |
|
The Quality of the WiFi Signal is @100%, because the access ... Im Forum Buddy3D |
Vor 3 months |
|
Buddy Cam Core One Wifi connection failed after update to FW... Im Forum Buddy3D |
Vor 3 months |
|
I also report this issue, when sending a print file to conne... Im Forum Bugs & Errors |
Vor 4 months |
|
I Think something is in preparation.in Connect there is a li... Im Forum General discussion & User Experience & Ideas |
Vor 7 months |
|
Yes, i agree! a Widget would be really Nice, also the implem... Im Forum General discussion, announcements and releases |
Vor 10 months |
|
Hi, The same here, sometimes I have a connection, than tls- ... Im Forum Bugs & Errors |
Vor 10 months |
|
My Kit arrived yesterday and as many before, one part is sha... Im Forum General discussion, announcements and releases |
Vor 10 months |
|
Ok, Shipping from batch One. Ordered at 31.1. the Mail for O... Im Forum General discussion, announcements and releases |
Vor 11 months |
