Prusa3D Forum

Notifications

Clear all

raco66

Grupa: Zarejestrowany

Dołączył: 2020/06/07

Active Member

	I have (for the moment) solved my Thermal Anomaly. Opened m... In forum Hardware, firmware and software help	1 year temu
	I have exactly the same problem. Machine is all stock. Upgra... In forum Hardware, firmware and software help	1 year temu
	MK3s LCD Enclosure In forum General discussion, announcements and releases	2 years temu
	Thanks Diem. Turned out it was a bad contact on the fuse so... In forum Hardware, firmware and software help	3 years temu
	Thanks! I will check everything over once more and then met... In forum Hardware, firmware and software help	3 years temu
	Everything including the platen heat works OK until I try to... In forum Hardware, firmware and software help	3 years temu
	Burnt out extruder heater In forum Hardware, firmware and software help	3 years temu
	Extruder died In forum Hardware, firmware and software help	4 years temu
	@joantabb Joan - Yes they are. I should get some 16 gb`s tod... In forum PrusaSlicer	4 years temu
	Yes they all are good, for one file only and then they rever... In forum PrusaSlicer	4 years temu
	Prusa slicer SD cards In forum PrusaSlicer	4 years temu
	jsw - Thanks. Is there any available guidance as to how to d... In forum Assembly and first prints troubleshooting	4 years temu
	Filament change loop In forum Assembly and first prints troubleshooting	4 years temu

Statystyki Forum

559 Fora

62.8 K Tematy

442.4 K Posty

21 Online

67.4 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte