Prusa3D Forum

Notifications

Clear all

raco66

Skupina: Registrovaný

Přidal se: 2020/06/07

Active Member

	I have (for the moment) solved my Thermal Anomaly. Opened m... In forum Hardware, firmware and software help	před 1 year
	I have exactly the same problem. Machine is all stock. Upgra... In forum Hardware, firmware and software help	před 1 year
	MK3s LCD Enclosure In forum General discussion, announcements and releases	před 2 years
	Thanks Diem. Turned out it was a bad contact on the fuse so... In forum Hardware, firmware and software help	před 3 years
	Thanks! I will check everything over once more and then met... In forum Hardware, firmware and software help	před 3 years
	Everything including the platen heat works OK until I try to... In forum Hardware, firmware and software help	před 3 years
	Burnt out extruder heater In forum Hardware, firmware and software help	před 3 years
	Extruder died In forum Hardware, firmware and software help	před 4 years
	@joantabb Joan - Yes they are. I should get some 16 gb`s tod... In forum PrusaSlicer	před 4 years
	Yes they all are good, for one file only and then they rever... In forum PrusaSlicer	před 4 years
	Prusa slicer SD cards In forum PrusaSlicer	před 4 years
	jsw - Thanks. Is there any available guidance as to how to d... In forum Assembly and first prints troubleshooting	před 4 years
	Filament change loop In forum Assembly and first prints troubleshooting	před 4 years

Fórum Statistiky

566 Fóra

63.2 K Témata

444.2 K Příspěvky

21 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed