Prusa3D Forum

Notifications

Clear all

r4z0r7o3

Skupina: PreRegistered

Přidal se: 2025/12/13

Název: Member

	Mine was an assembled unit, but yes I believe it would confu... In forum Assembly and first prints troubleshooting	před 15 hours
	After loosening both screws, getting the belt all floppy-flo... In forum Assembly and first prints troubleshooting	před 18 hours
	Thanks guys. Yes, I was careful to always tighten/loosen bo... In forum Assembly and first prints troubleshooting	před 19 hours
	Firmware belt tension wizard fails on lower belt In forum Assembly and first prints troubleshooting	před 2 days

Fórum Statistiky

595 Fóra

69.5 K Témata

486.5 K Příspěvky

14 Online

79.3 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed