Notifications
Clear all
Pyro Mick
Grupa: Zarejestrowany
Dołączył: 2024/10/02
Active Member
1
Thanks, Neophyl. I haven't used OrcaSlicer, and wasn't aware... In forum PrusaSlicer |
7 months temu | |
Force external perimeters to print same direction? In forum PrusaSlicer |
7 months temu | |
Dan82, Your comments validate some other glitches that I hav... | 11 months temu | |
I am also experiencing this with my new MK4S (kit), and I am... | 12 months temu | |
I have also seen some "spot anomalies" on prints from my new... | 12 months temu | |
Thanks for the reply, Iftibashir. I had gone through those e... In forum Hardware, firmware and software help |
12 months temu | |
Can't add MK4S profile in Prusa Slicer In forum Hardware, firmware and software help |
12 months temu |