Notifications
Clear all
Pyro Mick
Skupina: Registrovaný
Přidal se: 2024/10/02
Active Member
1
|
Thanks, Neophyl. I haven't used OrcaSlicer, and wasn't aware... In forum PrusaSlicer |
před 2 months | |
|
Force external perimeters to print same direction? In forum PrusaSlicer |
před 2 months | |
| Dan82, Your comments validate some other glitches that I hav... | před 6 months | |
| I am also experiencing this with my new MK4S (kit), and I am... | před 7 months | |
| I have also seen some "spot anomalies" on prints from my new... | před 7 months | |
|
Thanks for the reply, Iftibashir. I had gone through those e... In forum Hardware, firmware and software help |
před 7 months | |
|
Can't add MK4S profile in Prusa Slicer In forum Hardware, firmware and software help |
před 7 months |