Notifications
Clear all
Pyro Mick
Group: Registered
Joined: 2024/10/02
Active Member
1
|
Thanks, Neophyl. I haven't used OrcaSlicer, and wasn't aware... In forum PrusaSlicer |
2 months ago | |
|
Force external perimeters to print same direction? In forum PrusaSlicer |
2 months ago | |
| Dan82, Your comments validate some other glitches that I hav... | 6 months ago | |
| I am also experiencing this with my new MK4S (kit), and I am... | 6 months ago | |
| I have also seen some "spot anomalies" on prints from my new... | 6 months ago | |
|
Thanks for the reply, Iftibashir. I had gone through those e... In forum Hardware, firmware and software help |
6 months ago | |
|
Can't add MK4S profile in Prusa Slicer In forum Hardware, firmware and software help |
6 months ago |