Prusa3D Forum

Notifications

Clear all

powerpc750

Groupe: Enregistré

A(ont) rejoint: 2025/03/31

Active Member

	Thank you, I put a ground wire on the XY motor and it was do... Dans le forum Hardware, firmware and software help	il y a 2 weeks
	Questions about frequent power resets during printing Dans le forum Hardware, firmware and software help	il y a 2 weeks
	I am doing this to simplify things without complicated setti... Dans le forum How do I print this? (Printing help)	il y a 9 months
	I am using the Kit's core one and cheap TPU. I am a beginner... Dans le forum How do I print this? (Printing help)	il y a 9 months
	I loosened the idler screw a little, turned off the idler, i... Dans le forum How do I print this? (Printing help)	il y a 10 months
	I assembled the kit and couldn't get it to display on the fi... Dans le forum Hardware, firmware and software help	il y a 10 months
	Calibration & First run LCD blackout Dans le forum Assembly and first prints troubleshooting	il y a 10 months
	I wonder when the kit and nozzle I ordered on March 31 will ... Dans le forum General discussion, announcements and releases	il y a 11 months

Statistiques du forum

598 Forums

71.3 K Sujets

500.4 K Messages

14 En-ligne

82.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé