Prusa3D Forum

Notifications

Clear all

pokon_nurdspace

Skupina: Registrovaný

Přidal se: 2022/05/31

Active Member

	may be a silly question, but is there a draft in the room? i... In forum How do I print this? (Printing help)	před 2 years
	is z-hop enabled? also can you post pics of the failed atte... In forum How do I print this? (Printing help)	před 2 years
	i can recommend the guide from cnc kitchen In forum How do I print this? (Printing help)	před 2 years
	The MAXTEMP error occurs when at least one of the temperatur... In forum Hardware, firmware and software help	před 2 years
	It sounds like the extruder motor is skipping steps, do you ... In forum Hardware, firmware and software help	před 2 years
	if i can recall correctly i removed the idler door and i cou... In forum Hardware, firmware and software help	před 2 years
	i had the same problem, what happen was that the grubscrew i... In forum Hardware, firmware and software help	před 2 years

Fórum Statistiky

559 Fóra

62.8 K Témata

442.4 K Příspěvky

19 Online

67.4 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed