|
That's a useful insight, thank you. I've only used the Prusa... En el foro Hardware, firmware and software help |
hace 10 months |
|
Hi Walter -- thanks again. I guess it would make sense to ch... En el foro Hardware, firmware and software help |
hace 10 months |
|
I just discovered that there is a setting in Prusa Slicer to... En el foro Hardware, firmware and software help |
hace 10 months |
|
Hi, thanks. Yes, I am old enough to remember the 8.3 DOS day... En el foro Hardware, firmware and software help |
hace 10 months |
|
Thanks for your comment. The printer was at room temperature... En el foro Hardware, firmware and software help |
hace 10 months |
|
M112 error when sending gcode from Octoprint to MK3.5S but p... En el foro Hardware, firmware and software help |
hace 10 months |
|
@neophyl Ok, thanks. I'll look for the discussion on GitHub.... En el foro PrusaSlicer |
hace 5 years |
|
Another thing -- notice that the Rotation values are X=90, Y... En el foro PrusaSlicer |
hace 5 years |
|
Is anyone else seeing an issue with modifier dimensions not ... En el foro PrusaSlicer |
hace 5 years |
|
It works. You just need to make sure you enter the actual la... En el foro Print tips (Archive) |
hace 7 years |
