PJR – Activité – Prusa3D Forum

Notifications

Clear all

PJR

Groupe: Modérateur

A(ont) rejoint: 2015/06/01

Titre: Antient Member Moderator

	I'm not sure if it me or what but it seams a bit clunky. ... Dans le forum Software (Archive)	il y a 8 years
	Liquified plastic was stuck in the heat block threads. Usu... Dans le forum Improvements (Archive)	il y a 8 years
	I've been working on a mount for the Titan Aero for the MK2/... Dans le forum Improvements (Archive)	il y a 8 years
	That's only 3mm steel frame; probably won't be any better th... Dans le forum Improvements (Archive)	il y a 8 years
	Had a little stringing but the print quality was spot on wit... Dans le forum Assembly and first prints troubleshooting	il y a 8 years
	When installing the PTFE tube, did you loosen the heat break... Dans le forum Others (Archive)	il y a 8 years
	Humm. I don't do a lot; occasionally I clean the bed, but t... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	I even noticed with pronterface that the prusa sometimes did... Dans le forum Software (Archive)	il y a 8 years
	First print was Marvin and SUCCESS! Well that's great news... Dans le forum Assembly and first prints troubleshooting	il y a 8 years
	Well, there's no "Bowden Coupler" and no thermocouple on th... Dans le forum Improvements (Archive)	il y a 8 years
	Yup. The heat break is drilled from both ends and when dril... Dans le forum Others (Archive)	il y a 8 years
	Ok, so one one may keep the 3.0.11 driver while installing M... Dans le forum Others (Archive)	il y a 8 years
	Yes, but there really are too many differences, so the best ... Dans le forum Others (Archive)	il y a 8 years
	I really don't understand why this 4 month old thread has be... Dans le forum Others (Archive)	il y a 8 years
	Could slowing the retraction speed help at all? Theory wit... Dans le forum Others (Archive)	il y a 8 years
	There are some posts here regarding the slightly reduced pri... Dans le forum Others (Archive)	il y a 8 years
	Richard Did you have a look at either the firmware link or ... Dans le forum Others (Archive)	il y a 8 years
	The filament should be retracted a little at the end of the ... Dans le forum Others (Archive)	il y a 8 years
	Has anyone here managed to get the simple "change color on l... Dans le forum Others (Archive)	il y a 8 years
	The problem here is that none of us know what quality is acc... Dans le forum Print tips (Archive)	il y a 8 years

Page 93 / 281 Précédent Suivant

Statistiques du forum

585 Forums

68.4 K Sujets

478.8 K Messages

11 En-ligne

76.3 K Membres

Le dernier des messages: Camera stream Notre nouveau membre: rhn Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé