PJR – Activité – Prusa3D Forum

Notifications

Clear all

PJR

Groupe: Modérateur

A(ont) rejoint: 2015/06/01

Titre: Antient Member Moderator

	Hi Adam The fill used on Alalinda was 22%. Extrusion width... Dans le forum Print tips (Archive)	il y a 10 years
	Marvin, Adalinda, Castle, Tree Frog. All PLA and all with i... Dans le forum Print tips (Archive)	il y a 10 years
	Hi Adam First thing to do is to try printing one of the sup... Dans le forum Print tips (Archive)	il y a 10 years
	Marcin I wonder... If there is something preventing the X ... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Marcin Very strange. As far as I am aware, both the Z thre... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Anthony I presume you are heating the extruder before te... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Jack This issue of using full steps has been rolling around... Dans le forum Improvements (Archive)	il y a 10 years
	Jack There could be an issue if you secure the threaded rod... Dans le forum Improvements (Archive)	il y a 10 years
	In the latest firmware, the file is Configuration_prusa.h an... Dans le forum Improvements (Archive)	il y a 10 years
	Spencer I had a quick look around and the maximum printing ... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Spencer Peter Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Peter Not sure that you will see very much benefit. You... Dans le forum Improvements (Archive)	il y a 10 years
	Hi guys Unless you buy threaded rods made from stainless st... Dans le forum Improvements (Archive)	il y a 10 years
	Hi Spencer I don't think you want to change your MAX_TEMP s... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Yeah, PEI has been available for some time now, but I would ... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Just checked my PSU which has the same white glue holding th... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Amerigo Is that glue in the PSU or have the capacitors l... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Christophe Depends on slicer and settings used as to how... Dans le forum Print tips (Archive)	il y a 10 years
	Personally, I don't think this printer is designed to be ver... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	As Erron says, support can be very easily removed. I use bo... Dans le forum Print tips (Archive)	il y a 10 years

Page 249 / 281 Précédent Suivant

Statistiques du forum

598 Forums

70.9 K Sujets

497.3 K Messages

13 En-ligne

82.4 K Membres

Le dernier des messages: What are the usual measurements of neodymium magnets for 3D printing? Notre nouveau membre: Teen Patti Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé