Čeština
Fóra
Uživatelé
PJR
Aktivita
 
Notifications
Clear all
PJR
PJR
Skupina: Moderátor
Přidal se: 2015/06/01
Název: Antient Member Moderator
Profile Aktivita
Hi Adam The fill used on Alalinda was 22%. Extrusion width...

In forum Print tips (Archive)

 před 10 years
Marvin, Adalinda, Castle, Tree Frog. All PLA and all with i...

In forum Print tips (Archive)

 před 10 years
Hi Adam First thing to do is to try printing one of the sup...

In forum Print tips (Archive)

 před 10 years
Marcin I wonder... If there is something preventing the X ...

In forum Prusa i3 kit (Archive)

 před 10 years
Marcin Very strange. As far as I am aware, both the Z thre...

In forum Prusa i3 kit (Archive)

 před 10 years
Hi Anthony I presume you are heating the extruder before te...

In forum Prusa i3 kit (Archive)

 před 10 years
Jack This issue of using full steps has been rolling around...

In forum Improvements (Archive)

 před 10 years
Jack There could be an issue if you secure the threaded rod...

In forum Improvements (Archive)

 před 10 years
In the latest firmware, the file is Configuration_prusa.h an...

In forum Improvements (Archive)

 před 10 years
Spencer I had a quick look around and the maximum printing ...

In forum Prusa i3 kit (Archive)

 před 10 years
Hi Spencer Peter

In forum Prusa i3 kit (Archive)

 před 10 years
Hi Peter Not sure that you will see very much benefit. You...

In forum Improvements (Archive)

 před 10 years
Hi guys Unless you buy threaded rods made from stainless st...

In forum Improvements (Archive)

 před 10 years
Hi Spencer I don't think you want to change your MAX_TEMP s...

In forum Prusa i3 kit (Archive)

 před 10 years
Yeah, PEI has been available for some time now, but I would ...

In forum Prusa i3 kit (Archive)

 před 10 years
Just checked my PSU which has the same white glue holding th...

In forum Prusa i3 kit (Archive)

 před 10 years
Hi Amerigo Is that glue in the PSU or have the capacitors l...

In forum Prusa i3 kit (Archive)

 před 10 years
Hi Christophe Depends on slicer and settings used as to how...

In forum Print tips (Archive)

 před 10 years
Personally, I don't think this printer is designed to be ver...

In forum Prusa i3 kit (Archive)

 před 10 years
As Erron says, support can be very easily removed. I use bo...

In forum Print tips (Archive)

 před 10 years
Stránka 249 / 281
Share: