|
Roger
No matter; the problem is solved. I do rather like y... Nel forum Prusa i3 kit (Archive) |
10 years fa |
|
Ok, I see the problem.
My printer is running at the moment,... Nel forum Prusa i3 kit (Archive) |
10 years fa |
|
Yury
As per Stuart's post, you need to upgrade to firmware ... Nel forum Prusa i3 kit (Archive) |
10 years fa |
|
Yury
In that case, you have the Y end-stop in the wrong pos... Nel forum Prusa i3 kit (Archive) |
10 years fa |
|
OK, great we are getting somewhere.
Check out this photo:
... Nel forum Prusa i3 kit (Archive) |
10 years fa |
|
Ahhh
Yes I think I read that there is an issue with 3.0.0. ... Nel forum Prusa i3 kit (Archive) |
10 years fa |
|
OK, great
The heated bed should show continuity as it is on... Nel forum Others (Archive) |
10 years fa |
|
Hi
From what I understand, the heater is now not working at... Nel forum Others (Archive) |
10 years fa |
|
Joey
That's the one if you have a new Mk2.
Peter Nel forum Others (Archive) |
10 years fa |
|
Joey
3.0.1 was released a couple of days ago:
Peter Nel forum Others (Archive) |
10 years fa |
|
OK, just looked at the video again and I can hear the LCD bu... Nel forum Prusa i3 kit (Archive) |
10 years fa |
|
Roger
The problem here is that the GCode is not moving the ... Nel forum Prusa i3 kit (Archive) |
10 years fa |
|
Yeah, that's what I thought about motor wiring...
I can't s... Nel forum Prusa i3 kit (Archive) |
10 years fa |
|
Hi Yury
You either have your Y motor wired backwards or you... Nel forum Prusa i3 kit (Archive) |
10 years fa |
|
Christophe, Hi!
Ditto what Patrik has said. Anything print... Nel forum Awesome prints (Hall Of Fame) |
10 years fa |
|
Humm 3.0.0 is a tad faulty, hence the release of 3.0.1 over ... Nel forum Prusa i3 kit (Archive) |
10 years fa |
|
Andrew
There would be no harm in upgrading to 2.2.4, but I ... Nel forum Prusa i3 kit (Archive) |
10 years fa |
|
OK, I have sliced it with KISS with 0.25mm first layer 0.2mm... Nel forum Software (Archive) |
10 years fa |
|
Not sure as I don't use Slic3r.
And I don't want to guess, ... Nel forum Software (Archive) |
10 years fa |
|
Richard
Congrats on your century!
I do have a good feeling... Nel forum Software (Archive) |
10 years fa |
