|
Benjamin
I just use regular CPU thermal paste, but make sur... In forum Others (Archive) |
9 years ago |
|
Patrik
There have been issues with over-spray on the alumin... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Mitch
For the Mk1, the nozzle gap with standard firmware is... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Christophe
I don't have that issue, but then again, I don't... In forum Others (Archive) |
9 years ago |
|
Patrik
If the Z frame did not sit properly onto the Y frame... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Hi Shree
There should not be any issues with the screw as y... In forum Others (Archive) |
9 years ago |
|
Hi Joshua
This is more than likely either a connector, cabl... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Try this:
Open Pronterface and connect to the printer. Not... In forum Others (Archive) |
9 years ago |
|
Shreekumar
Thank you for your kind comments.
After moving ... In forum Others (Archive) |
9 years ago |
|
PEI has a glass transition temperature of 217 degrees, so pr... In forum Others (Archive) |
9 years ago |
|
Daniel
You have to remember that printing layers, the lines... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Patrik
I had exactly the same when my Y frame was not squar... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Tightening belts - I simply remove all except one screw from... In forum Others (Archive) |
9 years ago |
|
Justin
You have probably loaded the incorrect firmware. Y... In forum Others (Archive) |
9 years ago |
|
Another option (if you are printing PLA) is to use blue tape... In forum Hardware, firmware and software help |
9 years ago |
|
Hi Patrik
Printer your model last evening and it turned out... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Patrik
Sliced the model (attached), but can't print for a c... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Richard
Not according to this:
Delta printers home all on... In forum Others (Archive) |
9 years ago |
|
First thing; print your first layer much slower than the res... In forum Prusa i3 kit (Archive) |
9 years ago |
|
OK, got it. Will have a look at half-time...
Peter In forum Prusa i3 kit (Archive) |
9 years ago |
