|
Benjamin
I just use regular CPU thermal paste, but make sur... Im Forum Others (Archive) |
Vor 9 years |
|
Patrik
There have been issues with over-spray on the alumin... Im Forum Prusa i3 kit (Archive) |
Vor 9 years |
|
Mitch
For the Mk1, the nozzle gap with standard firmware is... Im Forum Prusa i3 kit (Archive) |
Vor 9 years |
|
Christophe
I don't have that issue, but then again, I don't... Im Forum Others (Archive) |
Vor 9 years |
|
Patrik
If the Z frame did not sit properly onto the Y frame... Im Forum Prusa i3 kit (Archive) |
Vor 9 years |
|
Hi Shree
There should not be any issues with the screw as y... Im Forum Others (Archive) |
Vor 9 years |
|
Hi Joshua
This is more than likely either a connector, cabl... Im Forum Prusa i3 kit (Archive) |
Vor 9 years |
|
Try this:
Open Pronterface and connect to the printer. Not... Im Forum Others (Archive) |
Vor 9 years |
|
Shreekumar
Thank you for your kind comments.
After moving ... Im Forum Others (Archive) |
Vor 9 years |
|
PEI has a glass transition temperature of 217 degrees, so pr... Im Forum Others (Archive) |
Vor 9 years |
|
Daniel
You have to remember that printing layers, the lines... Im Forum Prusa i3 kit (Archive) |
Vor 9 years |
|
Patrik
I had exactly the same when my Y frame was not squar... Im Forum Prusa i3 kit (Archive) |
Vor 9 years |
|
Tightening belts - I simply remove all except one screw from... Im Forum Others (Archive) |
Vor 9 years |
|
Justin
You have probably loaded the incorrect firmware. Y... Im Forum Others (Archive) |
Vor 9 years |
|
Another option (if you are printing PLA) is to use blue tape... Im Forum Hardware, firmware and software help |
Vor 9 years |
|
Hi Patrik
Printer your model last evening and it turned out... Im Forum Prusa i3 kit (Archive) |
Vor 9 years |
|
Patrik
Sliced the model (attached), but can't print for a c... Im Forum Prusa i3 kit (Archive) |
Vor 9 years |
|
Richard
Not according to this:
Delta printers home all on... Im Forum Others (Archive) |
Vor 9 years |
|
First thing; print your first layer much slower than the res... Im Forum Prusa i3 kit (Archive) |
Vor 9 years |
|
OK, got it. Will have a look at half-time...
Peter Im Forum Prusa i3 kit (Archive) |
Vor 9 years |
