PJR – Aktivita – Prusa3D Forum

Notifications

Clear all

PJR

Skupina: Moderátor

Přidal se: 2015/06/01

Název: Antient Member Moderator

	Jay Looks as though you have some sort of filament feed iss... In forum Others (Archive)	před 10 years
	Benjamin I just use regular CPU thermal paste, but make sur... In forum Others (Archive)	před 10 years
	Patrik There have been issues with over-spray on the alumin... In forum Prusa i3 kit (Archive)	před 10 years
	Mitch For the Mk1, the nozzle gap with standard firmware is... In forum Prusa i3 kit (Archive)	před 10 years
	Christophe I don't have that issue, but then again, I don't... In forum Others (Archive)	před 10 years
	Patrik If the Z frame did not sit properly onto the Y frame... In forum Prusa i3 kit (Archive)	před 10 years
	Hi Shree There should not be any issues with the screw as y... In forum Others (Archive)	před 10 years
	Hi Joshua This is more than likely either a connector, cabl... In forum Prusa i3 kit (Archive)	před 10 years
	Try this: Open Pronterface and connect to the printer. Not... In forum Others (Archive)	před 10 years
	Shreekumar Thank you for your kind comments. After moving ... In forum Others (Archive)	před 10 years
	PEI has a glass transition temperature of 217 degrees, so pr... In forum Others (Archive)	před 10 years
	Daniel You have to remember that printing layers, the lines... In forum Prusa i3 kit (Archive)	před 10 years
	Patrik I had exactly the same when my Y frame was not squar... In forum Prusa i3 kit (Archive)	před 10 years
	Tightening belts - I simply remove all except one screw from... In forum Others (Archive)	před 10 years
	Justin You have probably loaded the incorrect firmware. Y... In forum Others (Archive)	před 10 years
	Another option (if you are printing PLA) is to use blue tape... In forum Hardware, firmware and software help	před 10 years
	Hi Patrik Printer your model last evening and it turned out... In forum Prusa i3 kit (Archive)	před 10 years
	Patrik Sliced the model (attached), but can't print for a c... In forum Prusa i3 kit (Archive)	před 10 years
	Richard Not according to this: Delta printers home all on... In forum Others (Archive)	před 10 years
	First thing; print your first layer much slower than the res... In forum Prusa i3 kit (Archive)	před 10 years

Stránka 217 / 281 Předchozí Další

Fórum Statistiky

597 Fóra

70.7 K Témata

495.2 K Příspěvky

13 Online

82.1 K Uživatelé

Poslední Příspěvek: Worse prints and more noise after accelerometer calibration? Nový Uživatel: LuminusLupus Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed