Čeština
Fóra
Uživatelé
PJR
Aktivita
 
Notifications
Clear all
PJR
PJR
Skupina: Moderátor
Přidal se: 2015/06/01
Název: Antient Member Moderator
Profile Aktivita
Rob If you have a look at the instructions for preparing th...

In forum Improvements (Archive)

 před 10 years
I guess you're the 3D printing whisperer. No, not at all. ...

In forum Others (Archive)

 před 10 years
Now reduce the temperature try 195 to 200 degrees. Basicall...

In forum Others (Archive)

 před 10 years
Firmware is here: Open the zip, go to 1_75mm folder (for t...

In forum Improvements (Archive)

 před 10 years
Your GCode should contain the actual temperatures and not th...

In forum Others (Archive)

 před 10 years
Patrik Just checked my bed between prints. Set to 100 degr...

In forum Others (Archive)

 před 10 years
Shree had a similar issue with the grub screw; he had extra ...

In forum Others (Archive)

 před 10 years
Patrik I think print speed may be a clue. When in doubt, p...

In forum Others (Archive)

 před 10 years
Never user the colour print facility as I just edit the GCod...

In forum Software (Archive)

 před 10 years
Patrik There are some very useful hints here: Peter

In forum Others (Archive)

 před 10 years
In that case, you may have a high-resistance joint at the co...

In forum Others (Archive)

 před 10 years
Patrik You are totally correct. Apologies. Now post some ...

In forum Awesome prints (Hall Of Fame)

 před 10 years
I believe that if you don't have the same first layer height...

In forum Software (Archive)

 před 10 years
Never had any of those issues 😉 😉 I believe that Josef...

In forum Others (Archive)

 před 10 years
How can I find the layer height in Cura Multiply layer num...

In forum Software (Archive)

 před 10 years
Rob The i3 upgrade kit from E3D is intended for clone users...

In forum Improvements (Archive)

 před 10 years
Mike You don't need a new bed for that, just a PEI sheet wi...

In forum Others (Archive)

 před 10 years
Richard Josef had previously mentioned that there were very...

In forum Improvements (Archive)

 před 10 years
So the Slic3r build that comes with the MK2 is a custom buil...

In forum Software (Archive)

 před 10 years
Reduce retraction length to 0.5mm, increase retraction speed...

In forum Others (Archive)

 před 10 years
Stránka 207 / 281
Share: