Čeština
Fóra
Uživatelé
PJR
Aktivita
 
Notifications
Clear all
PJR
PJR
Skupina: Moderátor
Přidal se: 2015/06/01
Název: Antient Member Moderator
Profile Aktivita
Christophe I think Jeff has the wrong firmware loaded; the ...

In forum Others (Archive)

 před 10 years
Michael I wouldn't think so, but I have only had to change ...

In forum Others (Archive)

 před 10 years
Raise Z axis to at least 100mm, heat the nozzle and remove t...

In forum Others (Archive)

 před 10 years
Hi Nigel That looks good; can you post a picture of the fin...

In forum Awesome prints (Hall Of Fame)

 před 10 years
The M600 was simply "playing safe". I think the firmware do...

In forum General discussion, announcements and releases

 před 10 years
Mk1 bed connector issue

In forum Prusa i3 kit (Archive)

 před 10 years
You need to add G80 to the "long running commands" list. Go...

In forum General discussion, announcements and releases

 před 10 years
Jeff I have in the past and on many occasions been very cri...

In forum Others (Archive)

 před 10 years
Hi Joseph That is typical of over-extruded first layer. Th...

In forum Print tips (Archive)

 před 10 years
I would imagine that or the original design. If you let me ...

In forum Others (Archive)

 před 10 years
Hi Sylvain Have you ever tried to buy from AliExpress? It'...

In forum Others (Archive)

 před 10 years
Hi Sascha I think it most likely a model issue. Unfortunat...

In forum Others (Archive)

 před 10 years
Mahmoud I think the best thing to do is to contact support ...

In forum Prusa i3 kit (Archive)

 před 10 years
Hi Mahmoud Which printer and firmware are you running? Pet...

In forum Prusa i3 kit (Archive)

 před 10 years
Hi Jeff As Richard mentions, I use KISS, Cura and Craftware...

In forum Software (Archive)

 před 10 years
Looks like the RAMBo is a fair bit larger than the Mini. Yo...

In forum Prusa i3 kit (Archive)

 před 10 years
Patrik No. You have calibrated with a first layer of 0.15m...

In forum Prusa i3 kit (Archive)

 před 10 years
Marc The problem with that is that the bed height would cha...

In forum Others (Archive)

 před 10 years
Hi Kai There are generally 3 possibilities for the shifting...

In forum Prusa i3 kit (Archive)

 před 10 years
Patrik Sort of. I understand this will be changed in the n...

In forum Prusa i3 kit (Archive)

 před 10 years
Stránka 206 / 281
Share: