PJR – Activité – Prusa3D Forum

Notifications

Clear all

PJR

Groupe: Modérateur

A(ont) rejoint: 2015/06/01

Titre: Antient Member Moderator

	ZHop or Z-Lift is where the nozzle is raised during non-prin... Dans le forum General discussion, announcements and releases	il y a 9 years
	Philippe For PLA I use 60 degrees bed temp all the time and... Dans le forum Others (Archive)	il y a 9 years
	Shea I still think this is a cable issue. You may want to ... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	If the plastic is slightly harder, that can also cause over-... Dans le forum Print tips (Archive)	il y a 9 years
	Damian I tend to make a judgement based on the model. The ... Dans le forum Print tips (Archive)	il y a 9 years
	Thanks. Clock tower has one working clock, 27W LED lighting... Dans le forum Print tips (Archive)	il y a 9 years
	Sorry I don't remember that incident? I think Nigel may be ... Dans le forum Others (Archive)	il y a 9 years
	Yeah, I did that print as well, but at 175% The ribs are th... Dans le forum Print tips (Archive)	il y a 9 years
	You will normally have an air gap between raft and part to e... Dans le forum Others (Archive)	il y a 9 years
	Christian There are a few things you will need to get right... Dans le forum Others (Archive)	il y a 9 years
	Norman Ensure that the cabling from the rear of the extrude... Dans le forum Others (Archive)	il y a 9 years
	Shea Check that the cable is not trapped anywhere, especial... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Manuel There is only a single extruder heater, so the H1 is... Dans le forum Others (Archive)	il y a 9 years
	Last week I received the hot end upgrade and some of the soc... Dans le forum Others (Archive)	il y a 9 years
	James I think that the Live Adjust is only available during... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Bill The firmware defaults are: 40.925/4.875/86.085 and are... Dans le forum Improvements (Archive)	il y a 9 years
	Manuel The GCode Wiki is here: where everything is explain... Dans le forum Others (Archive)	il y a 9 years
	Manuel The extruder fan must be running 100% all the time o... Dans le forum Others (Archive)	il y a 9 years
	John Reorient the 3mm nylon filament in the bundle so that ... Dans le forum Others (Archive)	il y a 9 years
	Bill I found that I had to re-tune the heater PID after ins... Dans le forum Improvements (Archive)	il y a 9 years

Page 177 / 281 Précédent Suivant

Statistiques du forum

585 Forums

68.6 K Sujets

479.9 K Messages

12 En-ligne

76.9 K Membres

Le dernier des messages: Core One with MMU3 issue with Join Sppol Notre nouveau membre: Qohelath Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé