PJR – Aktivita – Prusa3D Forum

Notifications

Clear all

PJR

Skupina: Moderátor

Přidal se: 2015/06/01

Název: Antient Member Moderator

	ZHop or Z-Lift is where the nozzle is raised during non-prin... In forum General discussion, announcements and releases	před 9 years
	Philippe For PLA I use 60 degrees bed temp all the time and... In forum Others (Archive)	před 9 years
	Shea I still think this is a cable issue. You may want to ... In forum Prusa i3 kit (Archive)	před 9 years
	If the plastic is slightly harder, that can also cause over-... In forum Print tips (Archive)	před 9 years
	Damian I tend to make a judgement based on the model. The ... In forum Print tips (Archive)	před 9 years
	Thanks. Clock tower has one working clock, 27W LED lighting... In forum Print tips (Archive)	před 9 years
	Sorry I don't remember that incident? I think Nigel may be ... In forum Others (Archive)	před 9 years
	Yeah, I did that print as well, but at 175% The ribs are th... In forum Print tips (Archive)	před 9 years
	You will normally have an air gap between raft and part to e... In forum Others (Archive)	před 9 years
	Christian There are a few things you will need to get right... In forum Others (Archive)	před 9 years
	Norman Ensure that the cabling from the rear of the extrude... In forum Others (Archive)	před 9 years
	Shea Check that the cable is not trapped anywhere, especial... In forum Prusa i3 kit (Archive)	před 9 years
	Manuel There is only a single extruder heater, so the H1 is... In forum Others (Archive)	před 9 years
	Last week I received the hot end upgrade and some of the soc... In forum Others (Archive)	před 9 years
	James I think that the Live Adjust is only available during... In forum Prusa i3 kit (Archive)	před 9 years
	Bill The firmware defaults are: 40.925/4.875/86.085 and are... In forum Improvements (Archive)	před 9 years
	Manuel The GCode Wiki is here: where everything is explain... In forum Others (Archive)	před 9 years
	Manuel The extruder fan must be running 100% all the time o... In forum Others (Archive)	před 9 years
	John Reorient the 3mm nylon filament in the bundle so that ... In forum Others (Archive)	před 9 years
	Bill I found that I had to re-tune the heater PID after ins... In forum Improvements (Archive)	před 9 years

Stránka 177 / 281 Předchozí Další

Fórum Statistiky

585 Fóra

68.6 K Témata

479.9 K Příspěvky

9 Online

76.8 K Uživatelé

Poslední Příspěvek: Australian Import Duty And Tax Charges Added To Everything In Prusa Store Prior To Checkout? Nový Uživatel: Qohelath Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed