Aktywność
 
Notifications
Clear all
PJR
PJR
Grupa: Moderator
Dołączył: 2015/06/01
Tytuł: Antient Member Moderator
ZHop or Z-Lift is where the nozzle is raised during non-prin...

In forum General discussion, announcements and releases

9 years temu
Philippe For PLA I use 60 degrees bed temp all the time and...

In forum Others (Archive)

9 years temu
Shea I still think this is a cable issue. You may want to ...

In forum Prusa i3 kit (Archive)

9 years temu
If the plastic is slightly harder, that can also cause over-...

In forum Print tips (Archive)

9 years temu
Damian I tend to make a judgement based on the model. The ...

In forum Print tips (Archive)

9 years temu
Thanks. Clock tower has one working clock, 27W LED lighting...

In forum Print tips (Archive)

9 years temu
Sorry I don't remember that incident? I think Nigel may be ...

In forum Others (Archive)

9 years temu
Yeah, I did that print as well, but at 175% The ribs are th...

In forum Print tips (Archive)

9 years temu
You will normally have an air gap between raft and part to e...

In forum Others (Archive)

9 years temu
Christian There are a few things you will need to get right...

In forum Others (Archive)

9 years temu
Norman Ensure that the cabling from the rear of the extrude...

In forum Others (Archive)

9 years temu
Shea Check that the cable is not trapped anywhere, especial...

In forum Prusa i3 kit (Archive)

9 years temu
Manuel There is only a single extruder heater, so the H1 is...

In forum Others (Archive)

9 years temu
Last week I received the hot end upgrade and some of the soc...

In forum Others (Archive)

9 years temu
James I think that the Live Adjust is only available during...

In forum Prusa i3 kit (Archive)

9 years temu
Bill The firmware defaults are: 40.925/4.875/86.085 and are...

In forum Improvements (Archive)

9 years temu
Manuel The GCode Wiki is here: where everything is explain...

In forum Others (Archive)

9 years temu
Manuel The extruder fan must be running 100% all the time o...

In forum Others (Archive)

9 years temu
John Reorient the 3mm nylon filament in the bundle so that ...

In forum Others (Archive)

9 years temu
Bill I found that I had to re-tune the heater PID after ins...

In forum Improvements (Archive)

9 years temu
Strona 177 / 281
Share: