English
Forums
Members
PJR
Activity
 
Notifications
Clear all
PJR
PJR
Group: Moderator
Joined: 2015/06/01
Title: Antient Member Moderator
Profile Activity
ZHop or Z-Lift is where the nozzle is raised during non-prin...

In forum General discussion, announcements and releases

 9 years ago
Philippe For PLA I use 60 degrees bed temp all the time and...

In forum Others (Archive)

 9 years ago
Shea I still think this is a cable issue. You may want to ...

In forum Prusa i3 kit (Archive)

 9 years ago
If the plastic is slightly harder, that can also cause over-...

In forum Print tips (Archive)

 9 years ago
Damian I tend to make a judgement based on the model. The ...

In forum Print tips (Archive)

 9 years ago
Thanks. Clock tower has one working clock, 27W LED lighting...

In forum Print tips (Archive)

 9 years ago
Sorry I don't remember that incident? I think Nigel may be ...

In forum Others (Archive)

 9 years ago
Yeah, I did that print as well, but at 175% The ribs are th...

In forum Print tips (Archive)

 9 years ago
You will normally have an air gap between raft and part to e...

In forum Others (Archive)

 9 years ago
Christian There are a few things you will need to get right...

In forum Others (Archive)

 9 years ago
Norman Ensure that the cabling from the rear of the extrude...

In forum Others (Archive)

 9 years ago
Shea Check that the cable is not trapped anywhere, especial...

In forum Prusa i3 kit (Archive)

 9 years ago
Manuel There is only a single extruder heater, so the H1 is...

In forum Others (Archive)

 9 years ago
Last week I received the hot end upgrade and some of the soc...

In forum Others (Archive)

 9 years ago
James I think that the Live Adjust is only available during...

In forum Prusa i3 kit (Archive)

 9 years ago
Bill The firmware defaults are: 40.925/4.875/86.085 and are...

In forum Improvements (Archive)

 9 years ago
Manuel The GCode Wiki is here: where everything is explain...

In forum Others (Archive)

 9 years ago
Manuel The extruder fan must be running 100% all the time o...

In forum Others (Archive)

 9 years ago
John Reorient the 3mm nylon filament in the bundle so that ...

In forum Others (Archive)

 9 years ago
Bill I found that I had to re-tune the heater PID after ins...

In forum Improvements (Archive)

 9 years ago
Page 177 / 281
Share: