PJR – Activity – Prusa3D Forum

Notifications

Clear all

PJR

Group: Moderator

Joined: 2015/06/01

Title: Antient Member Moderator

	Hi Patrik Take a feed directly from the PSU, Id you remove... In forum Prusa i3 kit (Archive)	10 years ago
	ZHop or Z-Lift is where the nozzle is raised during non-prin... In forum General discussion, announcements and releases	10 years ago
	Philippe For PLA I use 60 degrees bed temp all the time and... In forum Others (Archive)	10 years ago
	Shea I still think this is a cable issue. You may want to ... In forum Prusa i3 kit (Archive)	10 years ago
	If the plastic is slightly harder, that can also cause over-... In forum Print tips (Archive)	10 years ago
	Damian I tend to make a judgement based on the model. The ... In forum Print tips (Archive)	10 years ago
	Thanks. Clock tower has one working clock, 27W LED lighting... In forum Print tips (Archive)	10 years ago
	Sorry I don't remember that incident? I think Nigel may be ... In forum Others (Archive)	10 years ago
	Yeah, I did that print as well, but at 175% The ribs are th... In forum Print tips (Archive)	10 years ago
	You will normally have an air gap between raft and part to e... In forum Others (Archive)	10 years ago
	Christian There are a few things you will need to get right... In forum Others (Archive)	10 years ago
	Norman Ensure that the cabling from the rear of the extrude... In forum Others (Archive)	10 years ago
	Shea Check that the cable is not trapped anywhere, especial... In forum Prusa i3 kit (Archive)	10 years ago
	Manuel There is only a single extruder heater, so the H1 is... In forum Others (Archive)	10 years ago
	Last week I received the hot end upgrade and some of the soc... In forum Others (Archive)	10 years ago
	James I think that the Live Adjust is only available during... In forum Prusa i3 kit (Archive)	10 years ago
	Bill The firmware defaults are: 40.925/4.875/86.085 and are... In forum Improvements (Archive)	10 years ago
	Manuel The GCode Wiki is here: where everything is explain... In forum Others (Archive)	10 years ago
	Manuel The extruder fan must be running 100% all the time o... In forum Others (Archive)	10 years ago
	John Reorient the 3mm nylon filament in the bundle so that ... In forum Others (Archive)	10 years ago

Page 177 / 281 Prev Next

Forum Statistics

598 Forums

71 K Topics

498.1 K Posts

12 Online

82.4 K Members

Latest Post: 6.5.3 Firmware for CORE One/+ Our newest member: Public username (required) Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed