PJR – Activité – Prusa3D Forum

Notifications

Clear all

PJR

Groupe: Modérateur

A(ont) rejoint: 2015/06/01

Titre: Antient Member Moderator

	That could be part of my problem. The XYZ calibration takes ... Dans le forum Others (Archive)	il y a 9 years
	Joan Leave the temperature the same throughout the print. ... Dans le forum Others (Archive)	il y a 9 years
	Do you change thr print? Joan Sorry, I don't understand th... Dans le forum Others (Archive)	il y a 9 years
	Joan I would advise not waiting to get the support filament... Dans le forum Others (Archive)	il y a 9 years
	Cyrille If you set Z Offset to -.05, then you will over-ext... Dans le forum Print tips (Archive)	il y a 9 years
	Hi Cyrille The Z_MIN has been my biggest issue with these p... Dans le forum Print tips (Archive)	il y a 9 years
	Paul Apologies for the grumpier members of this forum which... Dans le forum Others (Archive)	il y a 9 years
	I think it's worth testing out and exploring further. Absol... Dans le forum General discussion, announcements and releases	il y a 9 years
	Just to put a spanner in the works, and one that many will n... Dans le forum General discussion, announcements and releases	il y a 9 years
	If anything happened to PR (I'm sure it won't!) I'd be class... Dans le forum Others (Archive)	il y a 9 years
	John It is very simple. Just add a line in the GCode at a ... Dans le forum Software (Archive)	il y a 9 years
	Hi Marc Available here: Peter Dans le forum Others (Archive)	il y a 9 years
	Ben I realised a long time ago, that one-at-a-time is a far... Dans le forum Others (Archive)	il y a 9 years
	Ben If you have the name of a contact, then include that in... Dans le forum Others (Archive)	il y a 9 years
	Ben I don't think the pulley is an issue. This eccentric r... Dans le forum Others (Archive)	il y a 9 years
	The extruder stuttering like that indicates that you are try... Dans le forum Others (Archive)	il y a 9 years
	The majority of my orders have been shipped same or next day... Dans le forum Others (Archive)	il y a 9 years
	Printed Peter Dans le forum Print tips (Archive)	il y a 9 years
	Have you tried contacting support? If you purchased a pre-b... Dans le forum Others (Archive)	il y a 9 years
	This is E3D stance on heater block orientation: The issue w... Dans le forum Others (Archive)	il y a 9 years

Page 173 / 281 Précédent Suivant

Statistiques du forum

585 Forums

68.6 K Sujets

479.9 K Messages

11 En-ligne

76.9 K Membres

Le dernier des messages: Haftungsproblem mit Hilfe von Küchenfettentferner gelöst! Notre nouveau membre: Qohelath Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé