Activité
 
Notifications
Clear all
Philson
Philson
Groupe: Enregistré
A(ont) rejoint: 2016/11/06
Active Member
1
Hey Paul, I have the exact same issue since I updated the fi...

Dans le forum Hardware, firmware and software help

il y a 4 years
Updated release notes, hope it is more clear to others now :...

Dans le forum Assembly and first prints troubleshooting

il y a 7 years
Do you have a filament sensor connected to y-max connector? ...

Dans le forum Assembly and first prints troubleshooting

il y a 7 years
I tried all of them and some older files. Do you have a fi...

Dans le forum Assembly and first prints troubleshooting

il y a 7 years
I tried all of them and some older files.

Dans le forum Assembly and first prints troubleshooting

il y a 7 years
Hey all, I used the latest one from And after the error oc...

Dans le forum Assembly and first prints troubleshooting

il y a 7 years
Hey all, I have a weird glitch you guys might be able to he...

Dans le forum Assembly and first prints troubleshooting

il y a 7 years
Hey there guys, Well I worked the fine adjustments again on...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
I think I just found my mistake... I tried a different appro...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
Hey o/ So I had to redo the first test ... I was to tired (...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
Phil The calibration squares you printed - are they with or...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
Ok I am back at home and I've done some testing. To start t...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
No harm done Peter 🙂 I have tested this with a warm and a...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
"-" will lower the nozzle "+" will raise the nozzle from the...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
"-" will lower the nozzle "+" will raise the nozzle from the...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
Would be nice if you post any results you achieve! Seems lik...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
I have the same issue and I am working on in for quiet some ...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
Partager :