Prusa3D Forum

Notifications

Clear all

Philippe Collignon

Grupa: Zarejestrowany

Dołączył: 2015/09/29

Active Member

	Hello, Just a small feedback ..I managed to unclog it with... In forum Prusa i3 kit (Archive)	10 years temu
	Hello, Just a small feedback ..I managed to unclog it with... In forum Prusa i3 kit (Archive)	10 years temu
	Hello, I have the same issue (see two post below) .. Nozzle ... In forum Prusa i3 kit (Archive)	10 years temu
	My sd card reader is not working all the time neither .. I ... In forum Prusa i3 kit (Archive)	10 years temu
	Extruder nozzle stoppered / clogged In forum Prusa i3 kit (Archive)	10 years temu
	I had the same issue and ended by fixing the bed to the carr... In forum Prusa i3 kit (Archive)	10 years temu
	Small rings 5 mm radius 2 mm thikness In forum Awesome prints (Hall Of Fame)	10 years temu
	First print ABS and PLA In forum Awesome prints (Hall Of Fame)	10 years temu
	Default temp 50*C .. it tried hotter (60°C) but it was not b... In forum Prusa i3 kit (Archive)	10 years temu
	Howto ABS & PLA stick to heat bed In forum Prusa i3 kit (Archive)	10 years temu
	Congratulations and thanks ! In forum Prusa i3 kit (Archive)	10 years temu
	Fixing the Heat Bed In forum Prusa i3 kit (Archive)	10 years temu
	That was the problem .. using Slice3r and setting 1.75 filam... In forum Prusa i3 kit (Archive)	10 years temu
	Ok I got it, the bar must be pushed quite deep inside the pl... In forum Prusa i3 kit (Archive)	10 years temu
	Stuck at step 16 Axis Z .. In forum Prusa i3 kit (Archive)	10 years temu

Statystyki Forum

595 Fora

70 K Tematy

490.2 K Posty

13 Online

80.9 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte